RSSI DAX converts RSSI and LINK Quality from ImmersionRC receivers to analog voltage that almost any OSD (On Screen Display) reads. It supports both 3.3v and 5.0v mode.

rssidax_link

First you need to setup your EzUHF receiver to output RSSI or LINK Quality signal to selected output.
See your receiver’s manuals for setup details.

After you power RSSI converter you have 6 seconds to enter programing mode. You will see current selected mode (see table below). Press and hold button for 3 seconds to enter programing mode. Short button press will change mode and long button press will save last selected mode and exit programing mode.

LED indicator for different modes:

1 Blink RSSI input  →  Analog output 0 to 5.0v
☼☼ 2 Blinks LINK quality  →  Analog output 0 to 5.0v
☼☼☼ 3 Blinks RSSI input  →  Analog output 0 to 3.3v
☼☼☼☼ 4 Blinks LINK quality  →  Analog output 0 to 3.3v


When RSSI DAX is in operation, the RED LED will show you input signal strenght and the GREEN LED will show you output voltage.

MAXIMUM OPERATING VOLTAGE IS 5.0v
connecting RSSI DAX to higher voltage will burn it!

rssidax_render

RSSI DAX comes with JR servo lead connector for input and output.
Total length with cables is 20 cm / 8 in.

It supports following ImmersionRC receivers:
EzUHF Long-Range RC RX – 8 CH Diversity
EzUHF Long-Range RC RX – 8 CH Lite
EzUHF Long-Range RC RX – 4 CH



Here you can download RSSI DAX Manuals (PDF).